Jump to content


Community Status Updates


Photo

Redman

Left side headphone broke on my AKG k612s, only had them just over a year. Bullshit. Wanna move to monitors, but I don't have a space thats private/remote enough to mix using them. Gotta work with shitty $20 phones for now, ugh
Yesterday, 18:05
  • TheBellows's Photo
    TheBellows
    AKG used to make stuff that never breaks, but now they seem to only make flimsy crap. I really considered AKG last time i purchased headphones, but they felt like much more flimsy quality than the cheaper Beyerdynamics set i ended up with. I do not regret my purchase.
    Today, 19:10
  • TheBellows's Photo
    TheBellows
    Soldering is really not that hard, but it depends on where you need to solder. Usually the weak spots are where the cable connects with the headset or at the jack plug. It can be hard to make a transparent repair, but it shouldn't be hard to make it work again. Speakers rarely break, so it's not very likely they are busted.
    Today, 19:19
  • El°HYM's Photo
    El°HYM
    U can try to fix, yet agree with TheBellows, that normally they wont be able to be soldered properly, since the newer ones are built 2 break after a certain time. The cheapo Amazon is a Beast on the Bass & doesnt sound bad at all, just in case u need a Budget replace (less than 20$) The #Thomson is just a hidden Gem, if u can still find them somewhere...like 5 Buckz or something...juz grab & thank me laterz (:
    Today, 19:27
Photo

Redman

Looking for an old .xrns file on here that contained delay line commands that copied the swing settings of an Akai MPC (not sure which model). Can anyone redirect me to the file? I can't seem to find it
Jun 13 2018 02:48
  • El°HYM's Photo
    El°HYM
    These forums are almost confusing at some point.
    Jun 14 2018 17:20
  • Redman's Photo
    Redman
    Yeah think its lost now to the bottomless pit that is the forum, hoping i have it saved on an external somewhere. Ill probably just forget about it in a few days anyway once my attention span wanders off haha

    Jun 14 2018 23:14
  • El°HYM's Photo
    El°HYM
    Did u check Rpnz'z link, Mate?
    Jun 15 2018 15:32
Photo

Redman

Doing up income projections cause I'm an adult now and have to do the adult things that responsible adults do like good adults
Jun 08 2018 01:24
Photo

Redman

Psilocybin.....goddamn!!!!
May 20 2018 15:49
  • TheBellows's Photo
    TheBellows
    It was Roskilde Festival VS Panaeolus cyanescens. Ancient past like -98 or something. I went to the cozy part of Mordor, dancing my way through some Beastie Boys
    May 21 2018 08:21
  • El°HYM's Photo
    El°HYM
    Actually was referring to them Eagle - Wings & being immortal....yet, agree with u2, also funny that we still having people looking either like them good ol'orcs & trolls, today (: Beasties are my fav #jewish rappers of all time!
    May 21 2018 09:04
  • Zer0 Fly's Photo
    Zer0 Fly
    I've once seen a "future" where there were hovering/flying vehicles, like motocycles but with outer shell and an enclosed vertical disc like thing instead of wheels. seemed a very idyllic, lucid, bright place. I didn't need mushrooms for that... If I had taken mushrooms to see it, I'd just be tempted to BELIVE it was the real future, instead of just a presentation of what might be possible or not.
    May 21 2018 19:16
Photo

Redman

The daily grind is really getting me down
Apr 18 2018 21:40
  • encryptedmind's Photo
    encryptedmind
    So you reached a new low...nothing new.
    Apr 19 2018 13:51
  • TheBellows's Photo
    TheBellows
    wow, this encryptedmind guy really knows how to spread some good vibes.
    Apr 20 2018 11:34
Photo

Redman

Oh deary me
Apr 04 2018 01:29
Photo

Redman

Stagnation
Feb 19 2018 02:02
  • encryptedmind's Photo
    encryptedmind
    A country with 100 percent male occupancy dying to get to their local night club every weekend. A rerun of modern day Sodom and Gomorrah clone.
    Feb 21 2018 23:00
  • Redman's Photo
    Redman
    Oh right
    Feb 21 2018 23:39
Photo

Redman

And it's back to the building sites I go
Jan 13 2018 01:28
  • oneunkind's Photo
    oneunkind
    this means what? a regular job?
    Jan 13 2018 10:04
  • Redman's Photo
    Redman
    yeah man, hard labour all the way

    Jan 13 2018 12:30
  • oneunkind's Photo
    oneunkind
    nice, nice.
    Jan 13 2018 13:36
Photo

Redman

Colud somebody gimme 5 grand to buy a Make Noise Shared System please
Jan 08 2018 19:42
Photo

Redman

Just spent 3 hours programming 7 seconds of audio. Holy crap!!
Jan 03 2018 21:45
  • dblue's Photo
    dblue
    Ruddy heck, that sounds fuckin' mental! Nicely done, sir :)
    Jan 04 2018 19:34
  • Redman's Photo
    Redman
    Thanks man :)
    Jan 04 2018 19:51
  • midi error's Photo
    midi error
    i normally work the other way round
    Jan 05 2018 11:20
Photo

Redman

Way out in the water see it swimming
Dec 24 2017 07:33
  • oneunkind's Photo
    oneunkind
    what???? where is your mind?
    Dec 24 2017 07:58
  • Redman's Photo
    Redman
    wheeeeeeere is mai mynd
    Dec 24 2017 08:13
Photo

Redman

Was feeling kinda good about my ability to make music.....aaaaaand it's gone!
Dec 21 2017 06:39
  • Zer0 Fly's Photo
    Zer0 Fly
    maybe its just u and ur ears getting better, raising the bar you wish to fulfil but not experienced enough to meet the new expectations?
    Dec 21 2017 16:57
  • Redman's Photo
    Redman
    I think you pretty much nailed it right there all right. Kinda hit a plateau that I need to work through with study, experimentation, and experience. Good to be always wanting to improve and get better I suppose
    Dec 22 2017 04:27
  • Zer0 Fly's Photo
    Zer0 Fly
    Sometimes when I find myself in that situation, taking a break of a week or two will give me a fresh start & view on what I'm doing. Mind is revolving even when we do not use or notice. Normally strong urge and inspirations push me back to work on music sooner than I planned...
    Dec 22 2017 17:38
Photo

Redman

Whats the best groove settings for funky swinging drums?
Dec 19 2017 03:02
  • EatMe's Photo
    EatMe
    Most grooves come from volume accents. typical grooves would be counting in 2 and/or 3 count parts each after each other.
    Dec 20 2017 03:53
Photo

Redman

Software or hardware synth?
Dec 18 2017 03:13
  • Akiz's Photo
    Akiz
    ive bought some budget hw instruments and i dont use them enough because of user unfriendlines. Same with volca fm, there is FM V now, most friendly fm synth ever. I think that the software s got better money / value.
    Dec 18 2017 10:56
  • robohymn's Photo
    robohymn
    imo the only reason to go for hardware synths these days is if you are into analog and arent satisfied with analog emulations in software.
    Dec 18 2017 16:18
  • Zer0 Fly's Photo
    Zer0 Fly
    Build your style ITB, then when you are big fish you can afford the spleen to work with hardware...
    Dec 18 2017 20:48
Photo

Redman

Any way to lock a randomised lfo in the sample editor to integer octaves of the original pitch?
Dec 07 2017 05:31
  • Zer0 Fly's Photo
    Zer0 Fly
    tuning the lfos is on my todo list, I also popped on the idea to tune lfo modulations to (sub)harmonics of sounds. I need to find out a formula for the devices' sliders first. modulation lfo would need to be tuned from track/inst dsp/fx via formula devices, so no polyphony... but I'm busy trying to do sth for mbc10 right now...
    Dec 07 2017 16:52