How to make your music bounce to the beat.
Using a LFO + Hydra + Gainer.
If you can not see the DSP list, make sure you have opened the bottom pane and the DSP lanes at the left bottom..
Add to one track with your noise,
these devices in the DSP device list: LFO, Hydra, Gainer
in the Hydra, set the output device 1
to Gainer as output device 1
set the output parameter 1
to Gain as output parameter 1
set the Minimum Value of parameter 1 to -12 dB
and set the Maximum Value of parameter 1 to 0 dB
in the LFO set the LFO Amplitude to 100%
and select the LFO out device
set the Hydra as the LFO out device
select the LFO out parameter
set the Hydra Input as LFO out parameter
set the LFO envelope to "Custom"
draw a custom envelope similar to this one. you can add and remove points by double-clicking in the envelope.
set the LFO LPC (Lines Per Cycle of the LFO) equal to your tempo in Lines Per Beat, here: 8
Put a LFO reset command in the pattern by Right Clicking the LFO Reset button.
after navigating your pattern cursor to the start of the pattern in the track.
Select the effect lane block and Copy with Ctrl+C, sized equal to your LPB (8 lines here)
Repeat-Paste by navigating to the next line in the pattern editor and pressing Ctrl+P
You can select multiple target parameters and curves and minimum and maximum values to automate in the Hydra.
"Getting ready to get Renoising!" - a great person
"Renoise changes my nights into overnight success." - EatMe
"D.A.W. Renoise. What you need." - a customer
Edited by EatMe, 07 November 2017 - 14:30.