How to evenly fill in even value on effects column

I’m just getting back into Renoise and I know that there’s a simple way to fill in a whole load of effect commands evenly based on the first and last value of the section you’re programming but I’ve forgotten it.

So for example if you wanted to note slide from say xG00 on the first line to xG40 on your 16th command line you just put in those two commands and then highlight the rest and then there’s a key shortcut to fill everything in even increments based on how many lines there are between the two points.

I hope that makes sense.

Thanks

Make a selection within the Pattern Editor that includes the first and last values, then press Ctrl+I to interpolate between them.

AWESOME! Thank you.

This topic was automatically closed 12 hours after the last reply. New replies are no longer allowed.