Align Automation Curves

By holding down a certain key, e.g. shift, while raising/lowering the end point of an automation curve, the start point of the next pattern’s curve (if there is one) should align (move to the same level) respectively. And vice versa – if you set a curve’s start point, the previous curve’s end point should get the same value. This way you can more easily ensure smooth volume/whatever transitions.

Edit: I reckon this one hasn’t been discussed before.

Agree this would be useful, also the ability to use longer automation curves stretching over a number of patterns and being able to zoom in and out on these. Some of this has been suggested and discussed quite recently. Think (+ hope) that it is mostly planned and in the pipeline…