Automation View: Vertical Stretching By Using Mouse + Cmd

[kazakore]

It’s to do with Scaling, not dragging all points by the same amount in a direction.

possibility to stretch the automation points

I did just as bad job trying to explain it in my old thread but maybe it will help you understand anyway…

Simple Automation Transforms

OK, since my other thread with basic automation additions I’ve thought of a way to add a basic transform to the selected automation, but not quite so basic to suggest for 2.7. Some arbitrary automation may currently look like this: [image] On the edge of a selected area add a grab/transform bar at top and bottom. [image] You can select a point and drag down and it will truncate points that go below zero, which is the way moving multiple points currently works: [image] Only demonstrating…