hi folks!
i’m sitting here, making some speedcore and i automized the 2000hz frequencies for a bassdrum up to the thirtysecond row, as you can see on the picture.
i’d like to run this automation for the whole pattern but i don’t want to set each point by hand, because it’s too confusing i think.
so my question is: is it possible to copy the automation points i set and paste them into the automation window until it’s filled up at 128 rows? i want them to start the same way from 32 up to 64 as it starts from 0 to 32 and so on and so on…
any ideas or suggestions?
could you please tell me where i can find this? i’m not that deep into renoise, just started a while ago, and vst automation is defintely a new feature for me (barely understood automation in modplug…)
You can mark a part of the automation by click/drag above or below it.
If the focus is on the automation (it is focused if you can see some orange in the frame of it) then you can copy/paste using ctrl+c/v. Ctrl+p will paste continuously.
Use mouse rightclick options if you have not focused the automation window.
