How to send bank select with Midi CC 0 only?

Help, Support & Bugs
1

I’m trying to sequence my Dreadbox Typhon, using a normal DIN-5 midi cable from my MOTU interface, and “LineIn Ret” mode. The timing seems good enough, but I can’t choose the bank/program.

The Typhon is a bit peculiar in that it uses Midi CC 0 only, and not 32. If I use Inst Midi Control to send CC0 = 3, then PC 5, then it will select bank D, program 1 as selected. (Note: the Typhon menus are 1-indexed, not 0-indexed).

Is there any way I can get Renoise to send just CC 0 and not 0+32?

I tried putting this in as midi instrument controls, then sending them using the FX column but that seems to be ignored. If I manually click the bank (CC0), then PC under instrument midi controls then it does select the correct patch.

2

I just figured out a workaround. Midi CC 32 is mapped to a parameter on the VCA, but if I set Renoise to LSB, MSB mode - it will send CC 0 last which effectively overwrites the CC32 change.

Therefore bank 385, with LSB, MSB mode sends the sequence I want:
CC 32 = 0 (unnecessary, but can’t turn it off)
CC 0 = 3
PC = 6