Loop Points Modulation

[Moonriders]

@Jonas

link?

the content of the first link makes available the addresses /sample/loop_start & /sample/loop_end
and grabs the frame number from the selected sample.
then after executing the the script in the 2nd link, an XY gui to control them.

Insert into globalOscActions.lua:

Osc Discussion (How Where What To Use Osc)

I spent a good while looking at the OSC section of the prefs. Fucking beautiful! [:panic:] A few things stand out to me, like data types. “(number)” would denote integer or float, and from what I can tell the transport has no arguments but uses strings right? Also tried the evaluate example, but I’m not positive I wrote it correctly, does this need to be sent from the internal scripting? I started on making a touchOSC interface, but I keep getting my messages rejected, this might be due to t…

and what you copy over to the editor and execute in the editor to run it:

Osc Discussion (How Where What To Use Osc)

I spent a good while looking at the OSC section of the prefs. Fucking beautiful! [:panic:] A few things stand out to me, like data types. “(number)” would denote integer or float, and from what I can tell the transport has no arguments but uses strings right? Also tried the evaluate example, but I’m not positive I wrote it correctly, does this need to be sent from the internal scripting? I started on making a touchOSC interface, but I keep getting my messages rejected, this might be due to t…

edit the script or use port 8000 UDP