Hi!
For some cases I would like to have tighter frequency at LFO device. It could be useful f.ex. when producing effects. When I think of it again, it probably wouldn’t be useful for anything else. But it would. Be useful. For effects.
Maybe a button that switches LFO speed mode from slow to mid to fast or sumthing. So that we could have at even audible frequencies oscillating LFO’s. Which of course wouldn’t be that much Low Frequency Oscillators, but thats a term issue so let’s dismiss it right away.
Thanks for reading. Respect®ards
Mr. Kameleonth
The biggest caveat about the LFOdevice frequencies now in my opinion is that to make room for the kind of frequency spectrum people want, the actual frequencies most used (the lower ones) take up a ridiculously small area of the slider. I’ll say maybe once you get above 1/8 of the way the values are too high for typical use.
I’m still very partial to scaling sliders, where a manually typed value higher than the current max will “reset” the max value of the slider, much like how it works in Maya.
Isn’t the LFO meta-device tick-dependent? ie. if you went too fast and ‘syncronised’ with the passing of the ticks, the resulting value would be constantly flat?
