Sample DSP chain "Current Track" routing signal ends up in wrong track

[gentleclockdivider]

Create an instrument

Insert sequence data on track 3

Go to the instrument effects panel and insert two output busses (fx chains )

Bus 1 OUt routing should remain at : current track ( which is the sequenced track 3 )
Route the first bus to the second bus and keep source and put a reverb on the second bus
Put the second bus to totally wet and route it to track 5

Expected behaviour : bus 1 dry signal should appear at track 3 (where our sequence data resides ) , bus 2 wet signal should appear at track 5
However : both signals appear in track 5
Did not happen in previous versions of renoise
Here’s an example , load in previous version and current
Weird that this one got slipped under the radar .

www.xrns (5.7 KB)

current

[Jek]

When fx chain 01 is set to ‘current track’:
- Dry audio from track 3 is routed to Master, not track 5 (muted track 5).

When fx chain 01 is set to ‘track 3’ explicitly:
- Dry audio from track 3 is output on track 3.

Both cases FX chain 02 presents the 'wet’ signal on track 5.

**It seems this is a visualization issue.

[gentleclockdivider]

Current track = Implicit : the track on which the sequence data resides , and that is track 3 .
So it should go to track 3

It has always been like that in previous versions , untill now in 3.5

You say it’s not routed to track 5 but to the master directly , by muting it .

Try lowering the fader of track 5 , result is silence , so it’s def routed to track 5

[Jek]

It’s changed now for sure; I feel the changlog was not complete.
As a work-around or new work-flow, setting fx chain 01 to track 3 seems to fix it.