Don’t know if it’s possible, don’t even know a proper work-around, so here goes:
- an offset for the LFO device’s sequence-form whatchamacallit’s position?
- or perhaps as a substitute, automate presets?
Don’t know if it’s possible, don’t even know a proper work-around, so here goes:
you mean command x6yy?
x = position of LFO in the chain
yy = offset (00 = start, 80 = mid, FF = end)
It never occured to me that there was more to x6yy than x600
I’m crawling back to my corner and RTFM
Thanks IT!!
Try LFOing 06xx on another LFO for some good fun