Will Track Effects Effect Vsti's?

[Pinwizkid]

Hi there,

I’ve been using Renoise for a long time, but now that I am using VST instruments in nearly all of my songs, I thought I should ask this - how can I get in-pattern track effects to effect the sound that a VSTi is producing (such as a pitch bend, etc)? I’m trying to avoid sampling them because it decreases from the quality of the sound bank (unless I sample all of the audible pitches which would take forever to do and load back into Renoise). Any info is appreciated! Thanks

Brendan

[choice]

then your gonna need to know these. (at the very bottom of the page)

http://tutorials.renoise.com/?n=Renoise.EffectCommands

Panning column

• 00 - 80 - Set panning position of current subtrack.
  o 00 - most left
  o 40 - center
  o 80 - most right

• 9x - Panningslide left with step x (0 - f)

• ax - Panningslide right with step x (0 - f)

• bx - Play sample of subtrack note backwards (0 is backwards, 1 is forwards again, see 0bxx in effect column command-list)

• dx - Delay note x ticks (0 - f) dx and fx combination tricks

• ex - Retrig note x ticks (0 -f)

• fx - Cut note after x ticks (0 -f) dx and fx combination tricks

• MIDI / VSTI commands in panning column
  o 90 - Send CC Change, value in the effect-column (XXYY, XX = controller, YY = value)

• Controllers
• 01 - MOD wheel
  o 91 - Pitchbend, value in the effect-column (XXYY, XX global range, YY = finevalue)
• XX - 40 = center value, 40 - 7F = pitch-up, 40–01 = pitch down
• YY - 00 - 7F = finevalue range.
  o 92 - Program change, value in the effect-column (usually the last two bytes are used only (00 - 7F)

its also Very handy to have a copy of each of the vsti’s CC # lists
(usually at the end of most manuals)
helps a ton!