BPM/LPB/TPL Automation Overwrites Effect Commands In Pattern

If graphical automation is used to change BPM/LPB/TPL in the Master track (Points mode only obv.) then ZTxx/ZLxx/ZKxx effect commands will not function in the same pattern, even if the command and automation point are not on the same line. I assume this isn’t the intended behaviour since no other parameters behave like this?

I thought it was by design, that any automation lanes override any pattern commands. You have to use no automation lane on the pattern to make it work.

No, that only happens for other parameters when on the same line. This was already covered in the first post.