Little improvements for all devices using destination

If you look at the signal follower, it will reset it’s destination min/max values to INF and maximum, no matter what target is connected.

Instead, wouldn’t it make much more sense, if the reset is always the same as the target control? Let’s assume the destination is the gain slider of the gain device. Then on double click on destination min or max, it should reset to 0dB, just like a double-click on the gain-slider in the gain device. Same for velocity tracker etc…


made a thread about this once, setting up a signal follower device to hydra to gainers automatically sets the sliders max volume when selected, which can hurt speakers if done during playback. Would be great if a connected hydra could fetch the actual set value in the gainer/volume slider / any linked device parameter as max value automatically!